Product Name:DeRun SE Series Connector for IP20 & IP65 LED Strip



New SE series connector: the new design brings a safe, fast and convenient installation with led strip light.It not only achieves a rapid free welding connection, but no any length requirements to the layout of wire line.DeRun SE series connector improved the flexibility and convenience of the application site.It is easily to connect to the tin free wire and do not need to strip the wire skin.The conductor is not exposed, so it's very safe.It makes the cutted wires direct fast connection to come ture.SE series connectors have clear housing, ensure led emitting chip good light transmission.The innovative internal connetion structure brings better bite force between led strip light and connectors, more stable.

Housing: Polycarbonate
Contact chip: Environmental protection hardware material high precision copper
Contact chip surface treatment: Environmental protection and anti-corrosion treatment
Rated voltage:0-36V
Rated current:5A
Working temperature:-20 ℃~50 ℃
Temperature resistance:housing 105°C
Flame retardant grade: UL-94-V0
Conductor cross-section:0.35 mm²~0.75 mm ( AWG22~AWG18)
Wire diameter requirement(including insulation): Φ1.5 mm~Φ 2.1mm
Led strip requirement:8mm/10mm/12mm, IP20/IP65(silicone),sinlge color, RGB & RGBW
Led strip pcb requirement:Plating plate (not suitable for wire plate),thickness 0.25mm~0.35mm


1.Cut led strip in the cuttable mark
2.Peal off the 3M tape from led strip
3.Turn connector clear cover to 90 degree.
4.Put in led strip. Note that the led strip is on the top of the metal contact pin.
5.Lock the clear flip completely with the base on both sides with the aid of tools (electrician pliers)
Note:When the led strip is connected with the led strip, pay attention to the positive and negative polarity of the strip
6.Cut the length of the wire, without stripping the wire insulation, insert the guide slot
Note: When the led strip is connected with the wire, it should be noted that the positive and negative polarity of the strip should correspond to the positive and negative polarity of the wire
7.With the help of tools (electrician pliers) to lock the clear flip completely with the base on both sides
8.Installation finished

Some possible reasons if the electricity does not work:
1. Please check whether the wire is standard?
2. If the polarity of wire and strip is wrong?
3. If led strip PCB thickness is matching?
4. If the strip soldering pad is contacted with the metal contact sheet completely?
5. If led strip light is in good condition?

Contact Us :

We are looking forwarding to serving you.
Any questions please fill in the form below and we will reply to you within 12 hours, thank you!

Another Picture.