Regarding the IC led strip light controller, i have introduce the T1000S to you last week, hope the information could for your reference. I’d like to recommend the T-8000A-TTL to you~~

HTB1cfXbHFXXXXaDaXXXq6xXFXXX8 600x308 - LED Strip Lights Application Guide

T-8000A-TTL System Features
1. 32—256 Gray level,Support software Gamma correction。
2. Support the rules and special-shaped handle.
3. Eight–port output,every port can support 512-1024 pixels。
4. Off-line (SD Card) control, can be multiple controllers used in combination, play back content stored in
the SD card.
5.T-8000A store a maximum of 16 programs,copy multiple files to the SD card in order,after formatting the
SD card as “FAT” format.
6. The program must be named in orders ,just as :00_1.led, 01_1.led, 02_1.led.
7. Compatible with single and dual ICs, if you control a single line IC LED lights, without being connected
to the CLK line.
8. New T-8000A have a screen, the controller can be encrypted to limit the times of use.
NOTE: 1.When T-8000A controller control less than 512 lamps the frame rate can reach 30fps. When
T-8000S controls more than 512 lamps and less than 1024 lamps the frame rate will slow down
automatically.

rBVaHFWxNnmAU8AIAAE4QmciBcg304 600x421 - LED Strip Lights Application Guide

Physical parameters:
Working temperature :-30℃—85℃
Working voltage:DC5V
Working power:3W
Size:L200mm×W170mm×H50mm
Weight:0.8KG
Signal port:3pin connect port

t8000a - LED Strip Lights Application Guide

Question 1:After power,the T-8000S ERROR indicator has been flashing without
display output
answer:The ERROR indicator has been flashing means the controller did not read the card correctly, possible
problems:
①SD card is empty, with no effect file.
②The effect file in the SD card and the controller model are not match, please choose correct controller
model in LedEdit and then re-create the effect file *led.
③SD card did not format to FAT before copy effect files.
④Please check the supply power voltage, the controller can be individually powered to exclude power
reasons
⑤Changing the SD card and then test to exclude the possibility of a bad SD card
Question 2: The controller is powered on, the indicator is normal, but the lamps have no
effect changeAnswer: The reasons for this are as follows:
① Check if the lamp′s signal line and the controller connected correctly
② If the TTL signal is received, the lamp and the controller must be common ground, that means
connect the lamp′s and the controller′s ground wire together
③ Check if the model chose during making display files on the SD card match the chips used in the
lighting
Question 3:Controller and light connected, after. Lamps flicker. Controller indicator to
normal.
Answer:①The ground wire is not connected between the controller and lighting.
②The file in SD card is bad, Chip model does not match with the actual.
③Insufficient power supply.
Question 4:The SD card can not be formatted.
Answer:①First make sure the SD card on the side of the protection switch is already open.
②SD card reader is broken
③Do all of this can’t deal with the question. Change the SD card tests again.

rBVaGVSOYmyAaCQtAADwiZHVv8w758 600x431 - LED Strip Lights Application Guide

 

 

Click here to Inquiry Now